Chevy SBC 350 LowRise 1957-95 (Non Egr) Intake Manifold Black
|Part Type:||Intake Manifolds, Carbureted|
|Engine Block Style:||Stock/OEM standard deck|
|Intake Style:||Dual plane|
|Basic Operating RPM Range:||Idle-5,500|
|Intake Manifold Height:||4.050 in.|
|Notes:||Includes bushings for 1987-95 iron heads.|
The Speedmaster LowRise Manifolds are our lowest profile manifold and is also the only one that is street legal on pollution controlled vehicles. It is set up to accept a spread bore carb but comes with an adapter plate that permits the use of square bore carbs. To remain street legal with a square bore carb, you must use one that is also approved as street legal for your application.
This Speedmaster LowRise manifold is a direct replacement for the stock manifold on 1957-95 Small Block Chevy non-EGR engines.
Includes special adapter bushings to fit 1987-95 engines. Use the stock Quadra-Jet carb or 500-650 cfm vacuum secondary carburetor. Kit includes adapter plate to permit use of certain square bore style carburetors. Manifolds are cast from steel molds, not from sand molds. Permanent molds provide a tighter grain casting thereby reducing the occurrence of porosity which can mar the polished finish. Additionally, each Manifold is 100% pressure tested for leaks to eliminate installation problems. This is our most popular manifold and is showing up on many performance street machines and street rods.
50 STATE LEGAL.
Note: The 52000/52001 manifold is a stock replacement/street legal part for 302, 327, and 350 V8s with OEM carb or Edelbrock #1400 carb; 1966-72 (1973 non-CA) passenger cars, 1966-83 trucks and Suburbans, except stock equipped EGR. Also stock replacement/street legal for 302, 327 and 350 V8s with 1987-95 heads with OEM 4-bbl carb, except stock equipped EGR.
*Will not work on engines w/reverse flow heads as utilized on 1992-96 LT-1 Corvette, 1993-97 LT-1 Chevy Camaro, Pontiac Firebird, Chevy Caprice, Impala and Buick Roadmaster.