~BARGAIN BRAND NEW~ HOLDEN 355ci STROKER KIT "Convert your Motor into a 355 Cubic Inch Screamer"
SUITS: All 304 and 308 Rope Blocks. Neo Blocks need to get the rear main seal machined to suit.
1 x Cast Steel 355 Holden Stroker Crank 8 x 5.700" "H" Beam 3D Race Rods 8 x Silicon Skirt Hypotectic Pistons 1 x Procomp Race Moly Rings 1 x Procomp Full Gasket Kit 1 x Main and Con Rod Bearings
CAST STEEL CRANK Stroke: 3.48" / 355ci @ +030 Main Journal: STD Holden Con Rod Journal: STD Holden Straight Shot Internally Balanced Chamfered Oil Holes Ground & Micropolished Back Drillied Oiling System
FORGED "H" BEAM 3D SUPER RODS Rod Length: 5.700" Big End Journal: STD Holden Gudgen Pin Size: 0.927" 4340 Forged Steel Air Craft Material Matched weight sets (+/- 2 grams) Magnafluxed / Sonic tested & x-rayed Bronze bushings / heat treated / Stress relieved SILICON SKIRT HYPEREUTECTIC RACE PISTONS Pin Height: 1.425" Ring Groove: 1.5mm - 1.5mm - 3mm / 1/16 - 1/16 - 316 Valve Relif: 4 x (4cc Each) 30 percent stronger than ordinary pistons Their 100 percent CNC-machined crowns High upper compression-ring location and Gas-accumulator groove Drilled oil returns Spiral lock retainer grooves Tighter fit compared to forged types Provide improved oil control Reduce blowby Increase ring life Eliminate cold start-up knocking
COMPRESSION RATIO 10.5 TO 1 Based upon standard 304 & 308 heads and Standard Deck Block. This ratio perfect for Unleaded Pump fuel and maximum power. The piston will sit flat with the top of the Deck of the Block.
PLEASE SELECT YOUR PISTON SIZE
PISTON SIZE
STATUS
+ 030 PISTONS
IN STOCK
+ 040 PISTONS
IN STOCK
+ 060 PISTONS
IN STOCK
Want a better veiw of the Crank? Check out a customers video after installation.
Note: Crank has been balanced for "H" Beam Rods & Forged Pistons Crank is installed with all Main Bearings, Procomp Main Studs & Main Girdle
What to see the 355 Stroker Motor in action?
Here is the 355 Procomp Crate Motor, which i have all the parts up for sale in my shop.
WANT TO WATCH A STROKER KIT BEING INSTALLED Here is a breif stroker kit installation video, going through some of the stroker kit basics. Thanks ben and Procomp Motorsport.
Close up picture of the stroker kit FOR YOUR INFORMATION..... People ask how good is the PROCOMP GEAR??? I have been selling the PROCOMP gear for over 4 years with outstanding results. Visit JEGS.com who is one of the leading and biggest american retail outlets; who carry most of the PROCOMP range including the above CRANKS and CONRODS.
We accept
PayPal & Direct Deposit/Internet Banking
Shipping Calculator
Please select a QTY, your Country and Postcode (if you live in AUSTRALIA) or just your Country if outside of AUSTRALIA and click apply to receive a shipping quote in the table below.
Login / Register
Shopping Cart
